Light meter for UV A, B and C with RS232 outout series B107

For technical help or advice on this product, please submit your e-mail address and question here:

Support:  1-800-295-5693

HS Tariff:  9027.40.00.00

ISO-9000 Registered




The meter measures light intensity in micro watt / square cm.  The results of these measurements are sent to a PC.  The letters shown on the screen are the following for the measured values:

UVA = UV A light     UVA = UV B light     UVA = UV C light     TEM = ambient temperature


Technical Data:
Power: Powered from PC or PDA  (3.2...5 Volts @ 30 mA)
Materials: Housing = ABS natural   Seal = Sealon PTFE   Screws = stainless steel 301
Connection: 9 pole D connector (Palm adaptor available)
Work Distance: Any, just point it towards incoming light
Resolution: Within 0.1% accuracy in digital steps

User Instructions



Like any analytical instrument there are many other things you can do with it.  The output from your measurement shows in the PC and instead of using the calculated data’s from the sensor you can create your own calibration by using the formula above or other manipulations.



Instant analysis calibrates the light intensity in the microprocessor from the sensor. To recalibrate simply use your own calibration method = light intensity and correct the incoming data’s from the sensor. You always can use the values from the sensor as default. You can calculate the new values  or put the formula in your PC software.  Calibrated to 10 micro watt / square cm for max output.